Dynamically Calling Anonymous Blocks

This section describes how to execute anonymous blocks in dynamic statements. Append IN and OUT behind the EXECUTE IMMEDIATE…USING statement to input and output parameters.

Syntax

Figure 1 shows the syntax diagram.

Figure 1 call_anonymous_block::=

Figure 2 shows the syntax diagram for using_clause.

Figure 2 using_clause::=

The above syntax diagram is explained as follows:

  • The execute part of an anonymous block starts with a BEGIN statement, has a break with an END statement, and ends with a semicolon (;).
  • USING [IN|OUT|IN OUT]bind_argument: specifies where the variable passed to the stored procedure parameter value is stored. The modifiers in front of bind_argument and of the corresponding parameter are the same.
  • The input and output parameters in the middle of an anonymous block are designated by placeholders. The numbers of the placeholders and parameters are the same. The sequences of the parameters corresponding to the placeholders and the USING parameters are the same.
  • Currently in openGauss, when dynamic statements call anonymous blocks, placeholders cannot be used to pass input and output parameters in an EXCEPTION statement.
Feedback
编组 3备份
    openGauss 2024-05-24 00:44:50
    cancel